
Referentie: 18410-09
Low Nut M8x1
Low nut (Metric fine), used for pressure adjustment of the servo saver spring
Rear lower wishbone (3.5°) for the Cleon MMX.
Made from high grade dureable alloy (7075).
Assembly materials included.
Geen klantenbeoordelingen op het moment.
Referentie: 18410-09
Low nut (Metric fine), used for pressure adjustment of the servo saver spring
Referentie: 50900-12 H1
Upright for airbrake, right side. Assembling materials included.
Referentie: 50415-13 C3
Ball joint 5mm, left handed thread.For steering system and rear upper wishbone
Referentie: 18821 H1
Rose joint with rod-end.Rod-end has internal M6 thread- right handed.The hole in the ball-joint is 5mm.
Referentie: 51605 H3
Layshaft carrier, with possibility to mount the layshaft brake 51550.
Referentie: 51507 D3
Rear upper wishbone for the Cleon MMX and Imp4ctMade from the high grade alloy 7075. The turnbuckle has on its hex part a ring which marks the side of the left handed thread. Sold per piece.
Referentie: 51137-02
Adjustable top part of the spoiler carrier. The angle of the spoiler can herewith be adjusted in 5 different positions to your personal liking
Referentie: 51402 H4
Lower wishbone right, for the Cleon MMX and the Cleon '08. New improved lower front wishbone with the option to mount a stabilization bar. The wishbone has been also improved on strength by using impact simulation.
Referentie: 51408 H3
Shock tower for the Cleon MMX.Assembly materials included.
Referentie: 980070
Solid Elcon Models radio box. The lid has a groove in which the extra edge of the box fits, This secures a tight fit and makes the radio box watertight. Comes with a silicone wire to make the lid water tight and a rubber grommet for the servo cables. The needed hole for the grommet is to be drilled by the customer on his personal prefered position
Referentie: 51407 H3
Upper deck for the Cleon MMX.Delivered inclusive needed assembling materials
Referentie: 50445-06 B2
Bushing with conical collar for the servo saver. Inside Ø3mm Outside Ø4mm Fits ball joint (50320-20) which has a hole of Ø4mm
Rear lower wishbone (3.5°) for the Cleon MMX.
Made from high grade dureable alloy (7075).
Assembly materials included.