
Referentie: 18607 H2
Lay shaft
Lay shaft, made from stainless steel.The shaft is hollow to reduce weight.
Rear upright left/right for the Cleon MMX.
The rear upright is already prepared for the airbrakes.
Assembling materials and bearings included.
Geen klantenbeoordelingen op het moment.
Referentie: 50900-11 H1
Upright for airbrake, left side. Assembling materials included.
Referentie: 51813 A2
These quick shock mounts are ultra strong from stainless steel with an M5 thread to go in the damper bridge
Referentie: 70522 H1
Wheel shaft (HD) set for the rear of the Imp4ct, MMX and Cleon 08.The wheel shafts have the ball drive system and provided with M8 thread.Inclusive wheel nuts M8.
Referentie: 980070
Solid Elcon Models radio box. The lid has a groove in which the extra edge of the box fits, This secures a tight fit and makes the radio box watertight. Comes with a silicone wire to make the lid water tight and a rubber grommet for the servo cables. The needed hole for the grommet is to be drilled by the customer on his personal prefered position
Referentie: 51401 H4
Lower left front wishbone for the Cleon MMX and the Cleon '08. New improved lower front wishbone with the option to mount a stabilization bar. The wishbone has been also improved on strength by using impact simulation.
Referentie: 51137-02
Adjustable top part of the spoiler carrier. The angle of the spoiler can herewith be adjusted in 5 different positions to your personal liking
Referentie: 18410-09
Low nut (Metric fine), used for pressure adjustment of the servo saver spring
Referentie: 50320-20 C3
Ball joint 4mm used on shocker, stabi's, servosaver
Referentie: 51503-02 H4
Upper part for the shock tower of the rear for the Elcon Cleon.Assembly materials included.
Referentie: 51407 H3
Upper deck for the Cleon MMX.Delivered inclusive needed assembling materials
Referentie: 18701 A2
Bolt for mounting the shock absorber onto the aloy lower wishbones.
Referentie: 50415-13 C3
Ball joint 5mm, left handed thread.For steering system and rear upper wishbone
Referentie: 51211 H1
Set of steering servo mounts.Designed for large scale steering servos like the Rhino Digi 4 and alike.
Rear upright left/right for the Cleon MMX.
The rear upright is already prepared for the airbrakes.
Assembling materials and bearings included.