- Niet op voorraad
Referentie: 70300-04 A2
By-Pass shocker housing (front)
By-Pass shocker housing for the front shocker
Op voorraad
- Er zijn geen items meer in uw wagen
- Verzending
- Totaal € 0,00
Central gear plate
Waardering
Central gear plate for the Cleon MMX.
Assembly materials included.
Productdetails
51602 H4
Recensies
Geen klantenbeoordelingen op het moment.
16 andere producten in dezelfde categorie:
Referentie: 18603
Clutch bell carrier
Carrier for the clutch bell.Used on drive train 12600, 13600 and in the Cleon.
New version with carrier extension for the exhaust to the rear.
Op voorraad
Referentie: 50405 H3
Bulkhead B
Bulkhead B for the Elcon Cleon.Delivered inclusive needed assembling materials.
Op voorraad
Referentie: 51503-02 H4
Shock tower upper part
Upper part for the shock tower of the rear for the Elcon Cleon.Assembly materials included.
Op voorraad
Op voorraad
Referentie: 18807
Conical disc for steering system
Conical disc for the steering system with steel ball joints
Op voorraad
Referentie: 51813 A2
Shock quick mount with M5 (set)
These quick shock mounts are ultra strong from stainless steel with an M5 thread to go in the damper bridge
Op voorraad
Referentie: 18607 H2
Lay shaft
Lay shaft, made from stainless steel.The shaft is hollow to reduce weight.
Op voorraad
Referentie: 18410-09
Low Nut M8x1
Low nut (Metric fine), used for pressure adjustment of the servo saver spring
Op voorraad
Referentie: 51408 H3
Shock tower
Shock tower for the Cleon MMX.Assembly materials included.
Op voorraad
Referentie: 51105 B1
Down stop plates from steel (4pc.)
Steel down stop plates for the chassis
Op voorraad
Referentie: 51407 H3
Upper deck
Upper deck for the Cleon MMX.Delivered inclusive needed assembling materials
Op voorraad
Referentie: 18608
Clutch bell (ventilated)
Clutch bell with ventilation.Use only in combination with a teflon clutch.
Op voorraad
Referentie: 980070
Radio box (EM)
Solid Elcon Models radio box.
The lid has a groove in which the extra edge of the box fits, This secures a tight fit and makes the radio box watertight. Comes with a silicone wire to make the lid water tight and a rubber grommet for the servo cables. The needed hole for the grommet is to be drilled by the customer on his personal prefered position
Op voorraad
Referentie: 18821 H1
Rose joint with rod-end R
Rose joint with rod-end.Rod-end has internal M6 thread- right handed.The hole in the ball-joint is 5mm.
Op voorraad
Referentie: 45620-02
Clutch shoes (set 6 pcs)
6 pcs of clutch shoes for the 6-shoe teflon clutches
Op voorraad
Central gear plate for the Cleon MMX.
Assembly materials included.