
Referentie: 51813 A2
Shock quick mount with M5 (set)
These quick shock mounts are ultra strong from stainless steel with an M5 thread to go in the damper bridge
Rose joint with rod-end.
Rod-end has internal M6 thread- right handed.
The hole in the ball-joint is 5mm.
Geen klantenbeoordelingen op het moment.
Referentie: 51813 A2
These quick shock mounts are ultra strong from stainless steel with an M5 thread to go in the damper bridge
Referentie: 18603
Carrier for the clutch bell.Used on drive train 12600, 13600 and in the Cleon. New version with carrier extension for the exhaust to the rear.
Referentie: 18500
This differential is very strong and resistant to high forces that are imposed on the differential, especially in off-road racing.
Referentie: evo-023 C3
Stainless steel ball head with m4 right wire and a 4 mm hole for the serosaver to the servo
Referentie: 50405 H3
Bulkhead B for the Elcon Cleon.Delivered inclusive needed assembling materials.
Referentie: 51430 H1
Set of carbon twist plates for the Cleon MMX
Referentie: 50320-41 A4
Shock rod-end for shock shafts that have the M5 thread rolled ending.
Referentie: evo-0016
High grade oil for the differential.50 ml in a flacon. We advice to fill the differential with approximately 10~12ml of oil.So this is sufficient to re-fill your differential twice.
Referentie: 51415-11 H2
New steering lever, fits the new steering plate with miniature bearings. In the new lever are 3 mounting positions foreseen. Herewith you can achieve a better steering balance, it also allows more steering angle of the wheels. This has proven to be usefull especially on high grip tracks. The rear position is the same copies the original steering position...
Referentie: 50750-04
For the connection of the manifold and exhaust
Referentie: 50900-11 H1
Upright for airbrake, left side. Assembling materials included.
Referentie: 50900-12 H1
Upright for airbrake, right side. Assembling materials included.
Referentie: 51503-02 H4
Upper part for the shock tower of the rear for the Elcon Cleon.Assembly materials included.
Referentie: 51505
Upper wishbone mount for the Cleon MMX.Assembly materials included.
Referentie: 51210 H1
Set of servo mounts for the throttle brake.Allows a servo on top and servo mounting side ways.
Rose joint with rod-end.
Rod-end has internal M6 thread- right handed.
The hole in the ball-joint is 5mm.