

New steering lever, fits the new steering plate with miniature bearings.
In the new lever are 3 mounting positions foreseen. Herewith you can achieve a better steering balance, it also allows more steering angle of the wheels. This has proven to be usefull especially on high grip tracks.
The rear position is the same copies the original steering position of the older steering plate.
Geen klantenbeoordelingen op het moment.
Referentie: 51210 H1
Set of servo mounts for the throttle brake.Allows a servo on top and servo mounting side ways.
Referentie: 51511 H1
Rear upright left/right for the Cleon MMX. The rear upright is already prepared for the airbrakes.Assembling materials and bearings included.
Referentie: 51415-02 B2
Distance bush with flange for the new type of steering plate with miniature bearings. Made from stainless steel.
Referentie: 50121 D1
Set of pins for mounting in the side guards to fix your body on the side.Includes assembly material and body clips.
Referentie: 980070
Solid Elcon Models radio box. The lid has a groove in which the extra edge of the box fits, This secures a tight fit and makes the radio box watertight. Comes with a silicone wire to make the lid water tight and a rubber grommet for the servo cables. The needed hole for the grommet is to be drilled by the customer on his personal prefered position
Referentie: 18821 H1
Rose joint with rod-end.Rod-end has internal M6 thread- right handed.The hole in the ball-joint is 5mm.
Referentie: 45620-02
6 pcs of clutch shoes for the 6-shoe teflon clutches
Referentie: 18660-z118T
Z1 gear (pinion), mounted on the clutch bell. 18 T
Referentie: 18603
Carrier for the clutch bell.Used on drive train 12600, 13600 and in the Cleon. New version with carrier extension for the exhaust to the rear.
Referentie: 51105 B1
Steel down stop plates for the chassis
Referentie: 51408 H3
Shock tower for the Cleon MMX.Assembly materials included.
Referentie: 50406 H2
Steering base plate for the Elcon Cleon.Delivered inclusive needed assembling materials.
Referentie: 51211 H1
Set of steering servo mounts.Designed for large scale steering servos like the Rhino Digi 4 and alike.
New steering lever, fits the new steering plate with miniature bearings.
In the new lever are 3 mounting positions foreseen. Herewith you can achieve a better steering balance, it also allows more steering angle of the wheels. This has proven to be usefull especially on high grip tracks.
The rear position is the same copies the original steering position of the older steering plate.