Referentie: 80407 F3
Support front-end, left
Support for the front-end, left side of car.
Op voorraad
- Er zijn geen items meer in uw wagen
- Verzending
- Totaal € 0,00
- 1:10 Scale
- 1:6 Scale
- 1:8 Scale
- BBB-P Shocks
- Downloads
- Electronics
- Materials
- Silicone Oil
- Tools
Clutch spring
Waardering
Spring for the teflon clutch, sold per pc.
Omschrijving
18620-06
Productdetails
18620-06
3 Items
Recensies
Geen klantenbeoordelingen op het moment.
16 andere producten in dezelfde categorie:
Referentie: 80521 F4
Drive shaft rear
Drive shaft rear side Fourtex.
Incl. needed steel balls and springs.
Op voorraad
Referentie: 80501 F3
Dif mount left
Diff mount left, made from high grade alloy 7075.
Op voorraad
Referentie: 80701 F3
Motor mount small
Small motor mount made from high grade alloy 7075.
Op voorraad
Referentie: 70401
Lower wishbone
Lower wishbone for the IMP4CT and FourteX.
Fits front and rear, left and right
Op voorraad
Referentie: 80505 F4
PINION CARRIER
Pinion carrier, used on the rear and front of the Fourtex.
Op voorraad
Referentie: evo-0016
Oil for Differential
High grade oil for the differential.50 ml in a flacon.
We advice to fill the differential with approximately 10~12ml of oil.So this is sufficient to re-fill your differential twice.
Op voorraad
Referentie: 70300-30white
PROGRESSIVE SPRINGS 110MM WHITE
Progressive coloured springs for the by-pass shocks, (fits also Losi and bbb-p shocks)
Length: 110mm (with thread diameter 2.4mm)
Internal diameter: 32mm
Sold als pair.
Op voorraad
Referentie: 70412 F2
Upright L/R
Upright front, fits left + right.
Made from high grade 7075 aluminium.
Op voorraad
Referentie: 70529 B4
Guidance pin for spring Spline Drive (2pcs)
Guidance for the spring of the spline drive, inserted in the spline drive collar.
Delivered as a set.
Op voorraad
Referentie: 51105 B1
Down stop plates from steel (4pc.)
Steel down stop plates for the chassis
Op voorraad
Referentie: 980070
Radio box (EM)
Solid Elcon Models radio box.
The lid has a groove in which the extra edge of the box fits, This secures a tight fit and makes the radio box watertight. Comes with a silicone wire to make the lid water tight and a rubber grommet for the servo cables. The needed hole for the grommet is to be drilled by the customer on his personal prefered position
Op voorraad
Op voorraad
Referentie: evo-001 A4
SEAL FOR SHOCKER - ALL SHOCKS
Seal for shocker at the piston rod.Fits all Elcon shocks.
Op voorraad
Referentie: 70509 D3
PINS UPRIGHT, FRONT REAR (SET)
Pin set (stainless steel) for mounting the upright / c-hub on the front- and the rear wishbone.
The pin is mounted with 2 nyloc nuts and rings.
Op voorraad
Op voorraad
Spring for the teflon clutch, sold per pc.