
Referentie: 18410-09
Low Nut M8x1
Low nut (Metric fine), used for pressure adjustment of the servo saver spring
Shaft for the flex coupling with gear pressed on.
Geen klantenbeoordelingen op het moment.
Referentie: 18410-09
Low nut (Metric fine), used for pressure adjustment of the servo saver spring
Referentie: 18620-04
Coverplate from stainless steel for the teflon clutch
Referentie: 80509 F4
Rear upper arm made of high grade 7075 alloy.
Referentie: 51137-02
Adjustable top part of the spoiler carrier. The angle of the spoiler can herewith be adjusted in 5 different positions to your personal liking
Referentie: 50320-42 A2
Alloy Shock rod-end with plastic bushing for shock shafts that have the M5 thread rolled ending
Referentie: 8x22x7 A1
Lagers voor spline drive buitenzijde set van 2 stuks
Referentie: 980070
Solid Elcon Models radio box. The lid has a groove in which the extra edge of the box fits, This secures a tight fit and makes the radio box watertight. Comes with a silicone wire to make the lid water tight and a rubber grommet for the servo cables. The needed hole for the grommet is to be drilled by the customer on his personal prefered position
Referentie: 70509 D3
Pin set (stainless steel) for mounting the upright / c-hub on the front- and the rear wishbone. The pin is mounted with 2 nyloc nuts and rings.
Referentie: 80423
Output drive for the planet gear, used at the rear.
Referentie: 50121 D1
Set of pins for mounting in the side guards to fix your body on the side.Includes assembly material and body clips.
Referentie: 80506 F3
Support for the rear end of the FourteX, right side.
Referentie: 50750-04
For the connection of the manifold and exhaust
Referentie: 80605 F1A
Housing for the clutch bell. Machined from high grade 7075 alloy.
Shaft for the flex coupling with gear pressed on.