
Referentie: 51813 A2
Shock quick mount with M5 (set)
These quick shock mounts are ultra strong from stainless steel with an M5 thread to go in the damper bridge
Output drive for the planet gear, used at the rear.
Geen klantenbeoordelingen op het moment.
Referentie: 51813 A2
These quick shock mounts are ultra strong from stainless steel with an M5 thread to go in the damper bridge
Referentie: 80410 F2
Servo support for small steering servos, fits both left and right. Fits to the chassis with weelbase 620mm
Referentie: 80421 F4
Drive shaft front side Fourtex. Incl. needed steel balls and springs.
Referentie: 70521 B4
Drive shaft for the Spline-Drive. Delivered as set.
Referentie: 80405 F2
Bulkhead A/B for securing the wishbones. Made of high quality 7075 alloy.
Referentie: 70509 D3
Pin set (stainless steel) for mounting the upright / c-hub on the front- and the rear wishbone. The pin is mounted with 2 nyloc nuts and rings.
Referentie: 80508
Upper wishbone mount for the rear. Incl assembly materials.
Referentie: 18620-05
Pressure disc made from brass, fits the spring of the clutch. Used at clutch 50620 and 18620. Sold per pc.
Referentie: 80422 F4
Output drive for the planet gear, used at the front. Prepared for air brake.
Referentie: 18924 C1
Spherical ball bearing glued in alloy anodized link.The high end spherical ball bearing has a 5mm inner diameter.The alloy link has the M8 right handed thread inside.These ball links give a significant weight reduction compared with the steel version and has a better quality bearing than the steel version.
Output drive for the planet gear, used at the rear.