
Referentie: 51813 A2
Shock quick mount with M5 (set)
These quick shock mounts are ultra strong from stainless steel with an M5 thread to go in the damper bridge
For the connection of the manifold and exhaust
50750-04
Geen klantenbeoordelingen op het moment.
Referentie: 51813 A2
These quick shock mounts are ultra strong from stainless steel with an M5 thread to go in the damper bridge
Referentie: 51105 B1
Steel down stop plates for the chassis
Referentie: 51137-02
Adjustable top part of the spoiler carrier. The angle of the spoiler can herewith be adjusted in 5 different positions to your personal liking
Referentie: 70300-04 A2
By-Pass shocker housing for the front shocker
Referentie: 70413-02 C1
Disc for the pivot of the C-hub, which is mounted on top and under the C-hub for a smooth steering of the front upright
Referentie: 80110
Chassis for the Fourtex for wheelbase according EFRA regulations. Not including shorter drive shaft. The chassis length is reduced at the front. When using the front air brake it is needed to also replace the servo mounts and use small steering servos.
Referentie: 980070
Solid Elcon Models radio box. The lid has a groove in which the extra edge of the box fits, This secures a tight fit and makes the radio box watertight. Comes with a silicone wire to make the lid water tight and a rubber grommet for the servo cables. The needed hole for the grommet is to be drilled by the customer on his personal prefered position
Referentie: 18620-05
Pressure disc made from brass, fits the spring of the clutch. Used at clutch 50620 and 18620. Sold per pc.
Referentie: 70300-30green
Progressive coloured springs for the by-pass shocks, (fits also Losi shocks) Length: 110mm Internal diameter: 32mm Sold als pair. Chose your color Green = 2.1 mm Orange = 2.2 mm Bleu = 2.3 mm White = 2.4 mm Purple = 2.5 mm Red = 2.6 mm Grey = 2.7 mm
Referentie: 70521 B4
Drive shaft for the Spline-Drive. Delivered as set.
Referentie: 70102 B2
Side guard collar for fixing the side guards and top deck to the main chassis.
Referentie: 45520 B1
Adjustable shockertower extension. Makes your shocktower wider allowing a more vertical position of your rear shocks. This add lateral grip especialy on sand and cley tracks. Beside a wider position height can be adjusted as well in 3 positions for optimal use of small/big wheels.
Referentie: 50320-20 C3
Ball joint 4mm used on shocker, stabi's, servosaver
Referentie: 45900-09 C4
Rubber membrane for the air brake - mark II.
For the connection of the manifold and exhaust