

These quick shock mounts are ultra strong from stainless steel with an M5 thread to go in the damper bridge
On older models of Elcon (Cleon 08 and first series of the MMX) it is needed to tapper the M4 hole in the front/rear damper bridge to M5 thread.
The shock is secured with a nyloc M4 nut. 51813
Geen klantenbeoordelingen op het moment.
Referentie: 18410-09
Low nut (Metric fine), used for pressure adjustment of the servo saver spring
Referentie: 70320-10 A4
Spring disc for By-Pass shocks. Sold per piece.
Referentie: 70521 B4
Drive shaft for the Spline-Drive. Delivered as set.
Referentie: 45900-09 C4
Rubber membrane for the air brake - mark II.
Referentie: 80416 F2
Steering lever for mounting the steering plate and steering rods.
Referentie: evo-001 A4
Seal for shocker at the piston rod.Fits all Elcon shocks.
Referentie: 18924 C1
Spherical ball bearing glued in alloy anodized link. The high end spherical ball bearing has a 5mm inner diameter. The alloy link has the M8 right handed thread inside. These ball links give a significant weight reduction compared with the steel version and has a better quality bearing than the steel version.
Referentie: evo-023 C3
Stainless steel ball head with m4 right wire and a 4 mm hole for the serosaver to the servo
Referentie: 70524 B4
Spring set for the spline drive. Assures correct positioning of the drive shafts and dif shafts.
Referentie: 80602 F2
Shaft for the flex coupling with gear pressed on.
Referentie: 51137-02
Adjustable top part of the spoiler carrier. The angle of the spoiler can herewith be adjusted in 5 different positions to your personal liking
Referentie: 70528 B4
Ring for the spline drive to secure the pin. Made from alloy, anodized and laser engraved with Elcon logo.
Referentie: 50320-41 A4
Shock rod-end for shock shafts that have the M5 thread rolled ending.
These quick shock mounts are ultra strong from stainless steel with an M5 thread to go in the damper bridge