
Referentie: 45504 D3
B-mount rear
B-Mount for assembly of the wishbones on the rear. Including assembly materials.
Shaft for the spoiler carrier
51139
Geen klantenbeoordelingen op het moment.
Referentie: 45504 D3
B-Mount for assembly of the wishbones on the rear. Including assembly materials.
Referentie: 70320-40 A4
Piston rod / shock shaft with thread rolled M5 ending.By this much stronger thread rolled ending, the shock shaft is virtualy unbreakable
Referentie: 80608 F4
Ring gear with inner teeth (60T) for the planetary gears
Referentie: 70320-04
By-Pass shocker housing of the rear shocker
Referentie: 70528 B4
Ring for the spline drive to secure the pin. Made from alloy, anodized and laser engraved with Elcon logo.
Referentie: 45900-09 C4
Rubber membrane for the air brake - mark II.
Referentie: 980070
Solid Elcon Models radio box. The lid has a groove in which the extra edge of the box fits, This secures a tight fit and makes the radio box watertight. Comes with a silicone wire to make the lid water tight and a rubber grommet for the servo cables. The needed hole for the grommet is to be drilled by the customer on his personal prefered position
Referentie: 50320-20 C3
Ball joint 4mm used on shocker, stabi's, servosaver
Referentie: 70300-30orange
Progressive coloured springs for the by-pass shocks, (fits also Losi and bbb-p shocks) Length: 110mm (with thread diameter 2.2mm) Internal diameter: 32mm Sold als pair.
Referentie: 45503 D4
Rear shock tower made from high grade alloy 7075. Including needed assembly materials
Referentie: 50320-40-r
Piston rod / shock shaft with thread rolled M5 ending.By this much stronger thread rolled ending, the shock shaft is virtualy unbreakable.The shock rod-end that fits to this piston rod is partno: 50320-41 and 50320-42 Piston rod fits in shock absorber: 50320 and 70300
Referentie: 50445-06 B2
Bushing with conical collar for the servo saver. Inside Ø3mm Outside Ø4mm Fits ball joint (50320-20) which has a hole of Ø4mm
Shaft for the spoiler carrier