
Referentie: 70521 B4
Drive shaft for Spline-Drive (set)
Drive shaft for the Spline-Drive. Delivered as set.
Solid Elcon Models radio box.
The lid has a groove in which the extra edge of the box fits, This secures a tight fit and makes the radio box watertight. Comes with a silicone wire to make the lid water tight and a rubber grommet for the servo cables. The needed hole for the grommet is to be drilled by the customer on his personal prefered position
980070
Geen klantenbeoordelingen op het moment.
Referentie: 70521 B4
Drive shaft for the Spline-Drive. Delivered as set.
Referentie: 70300-30grey
Progressive coloured springs for the by-pass shocks, (fits also Losi and bbb-p shocks) Length: 110mm (with thread diameter 2.7mm) Internal diameter: 32mm Sold als pair.
Referentie: 70102 B2
Side guard collar for fixing the side guards and top deck to the main chassis.
Referentie: 80403 F4
Upper wishbone with normal and left handed thread. Made of high quality 7075 alloy.
Referentie: evo-0016
High grade oil for the differential.50 ml in a flacon. We advice to fill the differential with approximately 10~12ml of oil.So this is sufficient to re-fill your differential twice.
Referentie: 70300-30red
Progressive coloured springs for the by-pass shocks, (fits also Losi shocks) Length: 110mm (with thread diameter 2.6mm) Internal diameter: 32mm Sold als pair.
Referentie: 80509 F4
Rear upper arm made of high grade 7075 alloy.
Referentie: 8x22x7 A1
Lagers voor spline drive buitenzijde set van 2 stuks
Referentie: 18712
Used for example in the planet gears.
Referentie: 18807
Conical disc for the steering system with steel ball joints
Referentie: 70512-03
Insert with the amount of toe-in engraved. Can be mounted left and right. The upright slots into the insert for a rock solid mounting. Make your choice below. Available options 1,2,3,4 and 5 degrees. (Default option is 3 degrees)
Referentie: 50445-06 B2
Bushing with conical collar for the servo saver. Inside Ø3mm Outside Ø4mm Fits ball joint (50320-20) which has a hole of Ø4mm
Referentie: 40800-20 F4
Crownwheel made from high quality steel, hardend, ready for tough conditions.
Referentie: 45503 D4
Rear shock tower made from high grade alloy 7075. Including needed assembly materials
Solid Elcon Models radio box.
The lid has a groove in which the extra edge of the box fits, This secures a tight fit and makes the radio box watertight. Comes with a silicone wire to make the lid water tight and a rubber grommet for the servo cables. The needed hole for the grommet is to be drilled by the customer on his personal prefered position