
Referentie: 80605 F1A
Housing clutch bell
Housing for the clutch bell. Machined from high grade 7075 alloy.
Lower wishbone for the IMP4CT and FourteX.
Fits front and rear, left and right
70401
Geen klantenbeoordelingen op het moment.
Referentie: 80605 F1A
Housing for the clutch bell. Machined from high grade 7075 alloy.
Referentie: 80111
Front cover, prevents against dirt and stones inside the front of your car.
Referentie: 80421 F4
Drive shaft front side Fourtex. Incl. needed steel balls and springs.
Referentie: 80613 F3
Large motor mount for the Fourtex, made from high grade alloy 7075.
Referentie: 80417 F2
Steering lever for mounting the steering plate and steering rods.
Referentie: 18410-09
Low nut (Metric fine), used for pressure adjustment of the servo saver spring
Referentie: 80200
Fuel tank for the FourteX. Not included are fuel filter, gromets and fuel lines
Referentie: 70541
Complete set of spline drives shafts . 2CC of grease for the spline and 2CC of oil for lubrication of the CVD is delivered in the package. Wheel squares are not included.
Referentie: 45900-09 C4
Rubber membrane for the air brake - mark II.
Referentie: 70300-30grey
Progressive coloured springs for the by-pass shocks, (fits also Losi and bbb-p shocks) Length: 110mm (with thread diameter 2.7mm) Internal diameter: 32mm Sold als pair.
Referentie: 70300-04 A2
By-Pass shocker housing for the front shocker
Referentie: 70320-041
By-Pass shocker housing of the rear shocker
Referentie: 50320-20 C3
Ball joint 4mm used on shocker, stabi's, servosaver
Referentie: 50320-42 A2
Alloy Shock rod-end with plastic bushing for shock shafts that have the M5 thread rolled ending
Referentie: 70320-04
By-Pass shocker housing of the rear shocker
Lower wishbone for the IMP4CT and FourteX.
Fits front and rear, left and right