Upright rear L/R

Referentie: 80407 F3

Support front-end, left

Support for the front-end, left side of car.

Referentie: 80612 F2

Support planet gear, front

Support planet gear, front side. Made from high grade alloy 7075.

Referentie: evo-001 A4

SEAL FOR SHOCKER - ALL SHOCKS

Seal for shocker at the piston rod.Fits all Elcon shocks.

Referentie: 70320-15 A4

Volume compensation By-Pass shocks

VAT included Volume compensation for the By-Pass shock absorbers.

Referentie: 51415-02 B2

Distance bush steering plate

Distance bush with flange for the new type of steering plate with miniature bearings. Made from stainless steel.

Referentie: 18620-03A

DISTANCE BARREL (NEW TYPE)

Distance barrel for the clutch.(since 1-1-2015)Sold per piece.Fits the 45620, 80620, 18620 and the 50620 clutch. (clutches after 1-1-2015)

Referentie: 80701 F3

Motor mount small

Small motor mount made from high grade alloy 7075.

Referentie: 70401

Lower wishbone

Lower wishbone for the IMP4CT and FourteX. Fits front and rear, left and right

Referentie: 80110

Chassis Fourtex (shorter wheelbase)

Chassis for the Fourtex for wheelbase according EFRA regulations. Not including shorter drive shaft. The chassis length is reduced at the front. When using the front air brake it is needed to also replace the servo mounts and use small steering servos.

Referentie: 18500-07

Oil seals for the dif (set)

Referentie: 70413-02 C1

Disc for pivot C-hub

Disc for the pivot of the C-hub, which is mounted on top and under the C-hub for a smooth steering of the front upright

Referentie: 80613 F3

Motor mount large

Large motor mount for the Fourtex, made from high grade alloy 7075.

Referentie: 70320-10 A4

Spring disc By-Pass shock

Spring disc for By-Pass shocks. Sold per piece.

Referentie: 80405 F2

Bulkhead A/B

Bulkhead A/B for securing the wishbones. Made of high quality 7075 alloy.

Referentie: 50445-06 B2

Bushing with conical collar (Ø3mm/Ø4mm)

Bushing with conical collar for the servo saver. Inside Ø3mm Outside Ø4mm Fits ball joint (50320-20) which has a hole of Ø4mm

Referentie: 45140

Engine brace

Engine brace made from 7075 alloy. Prevents cracking of the fan cover and carter. Bolts straight onto Zenoah engines 23cc/26cc/29cc.