
Referentie: 80406 F3
Support front-end, right
Support for the front-end, right side of car.
Volume compensation for the By-Pass shock absorbers.
70320-15
Geen klantenbeoordelingen op het moment.
Referentie: 80406 F3
Support for the front-end, right side of car.
Referentie: 80605 F1A
Housing for the clutch bell. Machined from high grade 7075 alloy.
Referentie: 80613 F3
Large motor mount for the Fourtex, made from high grade alloy 7075.
Referentie: 51813 A2
These quick shock mounts are ultra strong from stainless steel with an M5 thread to go in the damper bridge
Referentie: 80509 F4
Rear upper arm made of high grade 7075 alloy.
Referentie: 70509 D3
Pin set (stainless steel) for mounting the upright / c-hub on the front- and the rear wishbone. The pin is mounted with 2 nyloc nuts and rings.
Referentie: 80419 F2
Bearing mount for steering axles, mounted on chassis. Bearing 18700 (16x8x5mm) fits this mount .
Referentie: 70625 F4
Drive cup for the rear pinion gear carrier, with star shape for double brake discs.
Referentie: 45503 D4
Rear shock tower made from high grade alloy 7075. Including needed assembly materials
Referentie: 70530 B4
Wheel shaft for the Spline-Drive. Delivered as set.
Referentie: 40800-20 F4
Crownwheel made from high quality steel, hardend, ready for tough conditions.
Referentie: 80205
Set of assembly materials for fixation of the fuel tank.
Referentie: 70532 B4
Center pin for the Spline-Drive. It is recommended to replace both parts Delivered as set.
Referentie: 70201_set
Battery strip from epoxy for the IMP4CT, TraxX and FourteX. Including needed mounting parts to bolt is straigth on your car.
Referentie: 80423
Output drive for the planet gear, used at the rear.
Referentie: 70554 F4
Brake disc for the central brake of the Imp4ct. 2pc. needed for the complete brake.
Volume compensation for the By-Pass shock absorbers.