
Referentie: 50320-41 A4
Shock rod-end (for M5)
Shock rod-end for shock shafts that have the M5 thread rolled ending.
Spring for the servo saver. (1piece)
18410-06
Geen klantenbeoordelingen op het moment.
Referentie: 50320-41 A4
Shock rod-end for shock shafts that have the M5 thread rolled ending.
Referentie: 18620-03A
Distance barrel for the clutch.(since 1-1-2015)Sold per piece.Fits the 45620, 80620, 18620 and the 50620 clutch. (clutches after 1-1-2015)
Referentie: 80505 F4
Pinion carrier, used on the rear and front of the Fourtex.
Referentie: 50320-20 C3
Ball joint 4mm used on shocker, stabi's, servosaver
Referentie: 50320-40-r
Piston rod / shock shaft with thread rolled M5 ending.By this much stronger thread rolled ending, the shock shaft is virtualy unbreakable.The shock rod-end that fits to this piston rod is partno: 50320-41 and 50320-42 Piston rod fits in shock absorber: 50320 and 70300
Referentie: 70300-30purple
Progressive coloured springs for the by-pass shocks, (fits also Losi and bbb-p shocks) Length: 110mm (with thread diameter 2.5mm) Internal diameter: 32mm Sold als pair.
Referentie: 80701 F3
Small motor mount made from high grade alloy 7075.
Referentie: 80602 F2
Shaft for the flex coupling with gear pressed on.
Referentie: 50445-06 B2
Bushing with conical collar for the servo saver. Inside Ø3mm Outside Ø4mm Fits ball joint (50320-20) which has a hole of Ø4mm
Referentie: 8x22x7 A1
Lagers voor spline drive buitenzijde set van 2 stuks
Referentie: 70401
Lower wishbone for the IMP4CT and FourteX. Fits front and rear, left and right
Referentie: 70530 B4
Wheel shaft for the Spline-Drive. Delivered as set.
Referentie: 80405 F2
Bulkhead A/B for securing the wishbones. Made of high quality 7075 alloy.
Referentie: 45511 B1
Splin-Drive upright for the rear of the TRAXX .and fourtex Fits both left and right side. Including bearings
Referentie: 70521 B4
Drive shaft for the Spline-Drive. Delivered as set.
Spring for the servo saver. (1piece)