- Niet op voorraad
Referentie: 70300-04 A2
By-Pass shocker housing (front)
By-Pass shocker housing for the front shocker
Op voorraad
- Er zijn geen items meer in uw wagen
- Verzending
- Totaal € 0,00
Steering plate
Waardering
Steering plate incl. all needed asembly materials and bushing and bearings.
Productdetails
80414 F2
Recensies
Geen klantenbeoordelingen op het moment.
16 andere producten in dezelfde categorie:
Referentie: 70320-041
+10MM BY-PASS SHOCKER HOUSING REAR
By-Pass shocker housing of the rear shocker
Op voorraad
Referentie: 80419 F2
Bearing mount
Bearing mount for steering axles, mounted on chassis.
Bearing 18700 (16x8x5mm) fits this mount .
Op voorraad
Referentie: 80508
Upper wishbone mount, rear
Upper wishbone mount for the rear.
Incl assembly materials.
Op voorraad
Referentie: 51105 B1
Down stop plates from steel (4pc.)
Steel down stop plates for the chassis
Op voorraad
Referentie: 70532 B4
CENTER PINS SPLINE-DRIVE (SET)
Center pin for the Spline-Drive.
It is recommended to replace both parts
Delivered as set.
Op voorraad
Referentie: 80410 F2
Servo support - small servo (w.b.620mm)
Servo support for small steering servos, fits both left and right.
Fits to the chassis with weelbase 620mm
Op voorraad
Op voorraad
Referentie: 45120
Side Guard L/R
Side guard for the TRAXX.
Fits both Left and Right.
Op voorraad
Referentie: 80613 F3
Motor mount large
Large motor mount for the Fourtex, made from high grade alloy 7075.
Op voorraad
Referentie: 70413-01 C1
Distance bush / pivot C-hub
Distance bush or pivot, which is mounted in the plastic bushings for a smooth steering of the front upright
Op voorraad
Referentie: evo-023 C3
Stainless steel ball head m4
Stainless steel ball head with m4 right wire and a 4 mm hole for the serosaver to the servo
Op voorraad
Referentie: 70411 F2
C-hub
C-hub for the front-end.
Made from high-grade 7075 alloy.
Includes all needed bushings.
Op voorraad
Referentie: 8x22x7 A1
lagers 8x22x7
Lagers voor spline drive buitenzijde set van 2 stuks
Op voorraad
Referentie: 80110
Chassis Fourtex (shorter wheelbase)
Chassis for the Fourtex for wheelbase according EFRA regulations.
Not including shorter drive shaft.
The chassis length is reduced at the front.
When using the front air brake it is needed to also replace the servo mounts and use small steering servos.
Op voorraad
Referentie: 80400-21
PINION CROWNWHEEL
Pinion for the crownwheel, fits both front and rear.
Op voorraad
Steering plate incl. all needed asembly materials and bushing and bearings.