Steering lever for mounting the steering plate and steering rods.
Geen klantenbeoordelingen op het moment.
Referentie: 80110
Chassis for the Fourtex for wheelbase according EFRA regulations. Not including shorter drive shaft. The chassis length is reduced at the front. When using the front air brake it is needed to also replace the servo mounts and use small steering servos.
Referentie: evo-003 B4
o-rings for fixation of the alloy securement ring of the spline drive. (set)
Referentie: 50750-04
For the connection of the manifold and exhaust
Referentie: 18620-03A
Distance barrel for the clutch.(since 1-1-2015)Sold per piece.Fits the 45620, 80620, 18620 and the 50620 clutch. (clutches after 1-1-2015)
Referentie: 70413-01 C1
Distance bush or pivot, which is mounted in the plastic bushings for a smooth steering of the front upright
Referentie: 40800-20 F4
Crownwheel made from high quality steel, hardend, ready for tough conditions.
Referentie: 80701 F3
Small motor mount made from high grade alloy 7075.
Referentie: 80521 F4
Drive shaft rear side Fourtex. Incl. needed steel balls and springs.
Referentie: 80605 F1A
Housing for the clutch bell. Machined from high grade 7075 alloy.
Referentie: 50121 D1
Set of pins for mounting in the side guards to fix your body on the side.Includes assembly material and body clips.
Referentie: 80600
Mount for the flex coupling, assembled to the flywheel.
Referentie: 980070
Solid Elcon Models radio box. The lid has a groove in which the extra edge of the box fits, This secures a tight fit and makes the radio box watertight. Comes with a silicone wire to make the lid water tight and a rubber grommet for the servo cables. The needed hole for the grommet is to be drilled by the customer on his personal prefered position
Steering lever for mounting the steering plate and steering rods.
