
Referentie: 70320-11 A2
Spring disc alloy for By-Pass shock
Spring disc for By-Pass shocks from alloy - blue anodized with logo engraved. Sold per piece.
Set of assembly materials for fixation of the fuel tank.
Geen klantenbeoordelingen op het moment.
Referentie: 70320-11 A2
Spring disc for By-Pass shocks from alloy - blue anodized with logo engraved. Sold per piece.
Referentie: 70413-01 C1
Distance bush or pivot, which is mounted in the plastic bushings for a smooth steering of the front upright
Referentie: 70412 F2
Upright front, fits left + right. Made from high grade 7075 aluminium.
Referentie: 8x22x7 A1
Lagers voor spline drive buitenzijde set van 2 stuks
Referentie: 70525 B4
Collar spline for the Spline-Drive. Delivered as set
Referentie: 80603 F1A
Housing for the starter, made from high grade 7075 alloy.
Referentie: 80506 F3
Support for the rear end of the FourteX, right side.
Referentie: 70509 D3
Pin set (stainless steel) for mounting the upright / c-hub on the front- and the rear wishbone. The pin is mounted with 2 nyloc nuts and rings.
Referentie: 18807
Conical disc for the steering system with steel ball joints
Referentie: 70401
Lower wishbone for the IMP4CT and FourteX. Fits front and rear, left and right
Referentie: 80407 F3
Support for the front-end, left side of car.
Referentie: 50415-13 C3
Ball joint 5mm, left handed thread.For steering system and rear upper wishbone
Referentie: 80417 F2
Steering lever for mounting the steering plate and steering rods.
Referentie: 18620-03A
Distance barrel for the clutch.(since 1-1-2015)Sold per piece.Fits the 45620, 80620, 18620 and the 50620 clutch. (clutches after 1-1-2015)
Referentie: 80110
Chassis for the Fourtex for wheelbase according EFRA regulations. Not including shorter drive shaft. The chassis length is reduced at the front. When using the front air brake it is needed to also replace the servo mounts and use small steering servos.
Set of assembly materials for fixation of the fuel tank.