Op voorraad
- Er zijn geen items meer in uw wagen
- Verzending
- Totaal € 0,00
- 1:10 Scale
- 1:6 Scale
- 1:8 Scale
- BBB-P Shocks
- Downloads
- ELCON
- ELCON
- Electronics
- Materials
- Silicone Oil
- Tools
Drive shaft for Spline-Drive (set)
Waardering
Drive shaft for the Spline-Drive.
Delivered as set.
Productdetails
70521 B4
1 Item
Recensies
Geen klantenbeoordelingen op het moment.
16 andere producten in dezelfde categorie:
Op voorraad
Referentie: 80200
Tank for Fourtex
Fuel tank for the FourteX.
Not included are fuel filter, gromets and fuel lines
Op voorraad
Referentie: 80406 F3
Support front-end, right
Support for the front-end, right side of car.
Op voorraad
Referentie: 51415-02 B2
Distance bush steering plate
Distance bush with flange for the new type of steering plate with miniature bearings.
Made from stainless steel.
Op voorraad
Referentie: 80111
Front Cover
Front cover, prevents against dirt and stones inside the front of your car.
Op voorraad
Referentie: 70413-02 A2
Disc for pivot C-hub
Disc for the pivot of the C-hub, which is mounted on top and under the C-hub for a smooth steering of the front upright
Op voorraad
Op voorraad
Referentie: 80417 F2
Steering lever L
Steering lever for mounting the steering plate and steering rods.
Op voorraad
Referentie: evo-001 A4
SEAL FOR SHOCKER - ALL SHOCKS
Seal for shocker at the piston rod.Fits all Elcon shocks.
Op voorraad
Referentie: evo-003 B4
O-ring spline (2 pcs)
o-rings for fixation of the alloy securement ring of the spline drive. (set)
Op voorraad
Referentie: 80205
Mounting set fuel tank
Set of assembly materials for fixation of the fuel tank.
Op voorraad
Referentie: 70532 B4
CENTER PINS SPLINE-DRIVE (SET)
Center pin for the Spline-Drive.
It is recommended to replace both parts
Delivered as set.
Op voorraad
Referentie: 18701 A2
Bolt for shocker (aloy whishbones)
Bolt for mounting the shock absorber onto the aloy lower wishbones.
Op voorraad
Referentie: 980070
Radio box (EM)
Solid Elcon Models radio box.
The lid has a groove in which the extra edge of the box fits, This secures a tight fit and makes the radio box watertight. Comes with a silicone wire to make the lid water tight and a rubber grommet for the servo cables. The needed hole for the grommet is to be drilled by the customer on his personal prefered position
Op voorraad
Referentie: 80505 F4
PINION CARRIER
Pinion carrier, used on the rear and front of the Fourtex.
Op voorraad
Drive shaft for the Spline-Drive.
Delivered as set.