
Referentie: 70320-04
By-Pass shocker housing rear
By-Pass shocker housing of the rear shocker
Center pin for the Spline-Drive.
It is recommended to replace both parts
Delivered as set.
70532
Geen klantenbeoordelingen op het moment.
Referentie: 70320-04
By-Pass shocker housing of the rear shocker
Referentie: 70320-40 A4
Piston rod / shock shaft with thread rolled M5 ending.By this much stronger thread rolled ending, the shock shaft is virtualy unbreakable
Referentie: 80419 F2
Bearing mount for steering axles, mounted on chassis. Bearing 18700 (16x8x5mm) fits this mount .
Referentie: 18620-05
Pressure disc made from brass, fits the spring of the clutch. Used at clutch 50620 and 18620. Sold per pc.
Referentie: 50415-13 C3
Ball joint 5mm, left handed thread.For steering system and rear upper wishbone
Referentie: 80507 F3
Support for the rear left of the FourteX.
Referentie: 980070
Solid Elcon Models radio box. The lid has a groove in which the extra edge of the box fits, This secures a tight fit and makes the radio box watertight. Comes with a silicone wire to make the lid water tight and a rubber grommet for the servo cables. The needed hole for the grommet is to be drilled by the customer on his personal prefered position
Referentie: 80506 F3
Support for the rear end of the FourteX, right side.
Referentie: 51105 B1
Steel down stop plates for the chassis
Referentie: 51415-02 B2
Distance bush with flange for the new type of steering plate with miniature bearings. Made from stainless steel.
Referentie: 80407 F3
Support for the front-end, left side of car.
Referentie: 80603 F1A
Housing for the starter, made from high grade 7075 alloy.
Referentie: 80423
Output drive for the planet gear, used at the rear.
Center pin for the Spline-Drive.
It is recommended to replace both parts
Delivered as set.