Brake axle

Referentie: 18620-03A

DISTANCE BARREL (NEW TYPE)

Distance barrel for the clutch.(since 1-1-2015)Sold per piece.Fits the 45620, 80620, 18620 and the 50620 clutch. (clutches after 1-1-2015)

Referentie: 80607 F1A

Housing ring gear

Housing for the ring gear. Made from high grade alloy 7075.

Referentie: 18500-07

Oil seals for the dif (set)

Referentie: 70300-04 A2

By-Pass shocker housing (front)

By-Pass shocker housing for the front shocker 

Referentie: 70412 F2

Upright L/R

Upright front, fits left + right. Made from high grade 7075 aluminium.

Referentie: 51415-02 B2

Distance bush steering plate

Distance bush with flange for the new type of steering plate with miniature bearings. Made from stainless steel.

Referentie: 45511 B1

Upright rear L/R

Splin-Drive upright for the rear of the TRAXX .and fourtex Fits both left and right side. Including bearings

Referentie: 80110

Chassis Fourtex (shorter wheelbase)

Chassis for the Fourtex for wheelbase according EFRA regulations. Not including shorter drive shaft. The chassis length is reduced at the front. When using the front air brake it is needed to also replace the servo mounts and use small steering servos.

Referentie: 80603 F1A

Housing starter

Housing for the starter, made from high grade 7075 alloy.

Referentie: 50900-04 C4

Spring air brake (10 pcs)

Spring for the air brake.10 pcs in one bag

Referentie: 50415-13 C3

Ball joint L

Ball joint 5mm, left handed thread.For steering system and rear upper wishbone

Referentie: 80111

Front Cover

Front cover, prevents against dirt and stones inside the front of your car.

Referentie: 8x22x7 A1

lagers 8x22x7

Lagers voor spline drive buitenzijde set van 2 stuks

Referentie: 70300-30green

PROGRESSIVE SPRINGS 110MM

Progressive coloured springs for the by-pass shocks, (fits also Losi shocks) Length: 110mm  Internal diameter: 32mm Sold als pair. Chose your color Green = 2.1 mm Orange = 2.2 mm Bleu = 2.3 mm White = 2.4 mm Purple = 2.5 mm Red = 2.6 mm Grey = 2.7 mm

Referentie: 70411 F2

C-hub

C-hub for the front-end. Made from high-grade 7075 alloy. Includes all needed bushings.

Referentie: 45520 B1

Shocktower extension

Adjustable shockertower extension. Makes your shocktower wider allowing a more vertical position of your rear shocks. This add lateral grip especialy on sand and cley tracks. Beside a wider position height can be adjusted as well in 3 positions for optimal use of small/big wheels.