Op voorraad
- Er zijn geen items meer in uw wagen
- Verzending
- Totaal € 0,00
COVER PLATE FOR CLUTCH
Waardering
Coverplate from stainless steel for the teflon clutch
Productdetails
18620-04
1 Item
Recensies
Geen klantenbeoordelingen op het moment.
16 andere producten in dezelfde categorie:
Referentie: 80406 F3
Support front-end, right
Support for the front-end, right side of car.
Op voorraad
Referentie: 70300-30green
PROGRESSIVE SPRINGS 110MM
Progressive coloured springs for the by-pass shocks, (fits also Losi shocks) Length: 110mm Internal diameter: 32mm Sold als pair. Chose your color Green = 2.1 mm Orange = 2.2 mm Bleu = 2.3 mm White = 2.4 mm Purple = 2.5 mm Red = 2.6 mm Grey = 2.7 mm
Op voorraad
Referentie: 50320-20 C3
Ball joint 4mm
Ball joint 4mm used on shocker, stabi's, servosaver
Op voorraad
Referentie: 50445-06 B2
Bushing with conical collar (Ø3mm/Ø4mm)
Bushing with conical collar for the servo saver. Inside Ø3mm Outside Ø4mm Fits ball joint (50320-20) which has a hole of Ø4mm
Op voorraad
Referentie: 45504 D3
B-mount rear
B-Mount for assembly of the wishbones on the rear. Including assembly materials.
Op voorraad
Op voorraad
Referentie: 80110
Chassis Fourtex (shorter wheelbase)
Chassis for the Fourtex for wheelbase according EFRA regulations. Not including shorter drive shaft. The chassis length is reduced at the front. When using the front air brake it is needed to also replace the servo mounts and use small steering servos.
Op voorraad
Referentie: 80200
Tank for Fourtex
Fuel tank for the FourteX. Not included are fuel filter, gromets and fuel lines
Op voorraad
Referentie: 70300-04 A2
By-Pass shocker housing (front)
By-Pass shocker housing for the front shocker
Op voorraad
Referentie: 80607 F1A
Housing ring gear
Housing for the ring gear. Made from high grade alloy 7075.
Op voorraad
Referentie: 45511 B1
Upright rear L/R
Splin-Drive upright for the rear of the TRAXX .and fourtex Fits both left and right side. Including bearings
Op voorraad
Referentie: 70509 D3
PINS UPRIGHT, FRONT & REAR (SET)
Pin set (stainless steel) for mounting the upright / c-hub on the front- and the rear wishbone. The pin is mounted with 2 nyloc nuts and rings.
Op voorraad
Referentie: 70524 B4
Spring Spline Drive (2pcs)
Spring set for the spline drive. Assures correct positioning of the drive shafts and dif shafts.
Op voorraad
Op voorraad
Referentie: 80521 F4
Drive shaft rear
Drive shaft rear side Fourtex. Incl. needed steel balls and springs.
Op voorraad
Coverplate from stainless steel for the teflon clutch