Pressure disc made from brass, fits the spring of the clutch.
Used at clutch 50620 and 18620.
Sold per pc.
Geen klantenbeoordelingen op het moment.
Referentie: 80110
Chassis for the Fourtex for wheelbase according EFRA regulations. Not including shorter drive shaft. The chassis length is reduced at the front. When using the front air brake it is needed to also replace the servo mounts and use small steering servos.
Referentie: 70532 B4
Center pin for the Spline-Drive. It is recommended to replace both parts Delivered as set.
Referentie: evo-023 C3
Stainless steel ball head with m4 right wire and a 4 mm hole for the serosaver to the servo
Referentie: 70300-30green
Progressive coloured springs for the by-pass shocks, (fits also Losi and bbb-p shocks) Length: 110mm (with thread diameter 2.1mm) Internal diameter: 32mm Sold als pair.
Referentie: 80421 F4
Drive shaft front side Fourtex. Incl. needed steel balls and springs.
Referentie: 80701 F3
Small motor mount made from high grade alloy 7075.
Referentie: 80505 F4
Pinion carrier, used on the rear and front of the Fourtex.
Referentie: 50320-41 A4
Shock rod-end for shock shafts that have the M5 thread rolled ending.
Referentie: 51813 A2
These quick shock mounts are ultra strong from stainless steel with an M5 thread to go in the damper bridge
Referentie: evo-0016
High grade oil for the differential.50 ml in a flacon. We advice to fill the differential with approximately 10~12ml of oil.So this is sufficient to re-fill your differential twice.
Referentie: 80414 F2
Steering plate incl. all needed asembly materials and bushing and bearings.
Referentie: 70300-30orange
Progressive coloured springs for the by-pass shocks, (fits also Losi and bbb-p shocks) Length: 110mm (with thread diameter 2.2mm) Internal diameter: 32mm Sold als pair.
Referentie: 70528 B4
Ring for the spline drive to secure the pin. Made from alloy, anodized and laser engraved with Elcon logo.
Pressure disc made from brass, fits the spring of the clutch.
Used at clutch 50620 and 18620.
Sold per pc.
