
Referentie: 18410-09
Low Nut M8x1
Low nut (Metric fine), used for pressure adjustment of the servo saver spring
Used between the rose joints and the uprights.
Hole size: Ø5mm
18806
Geen klantenbeoordelingen op het moment.
Referentie: 18410-09
Low nut (Metric fine), used for pressure adjustment of the servo saver spring
Referentie: 80111
Front cover, prevents against dirt and stones inside the front of your car.
Referentie: 50320-20 C3
Ball joint 4mm used on shocker, stabi's, servosaver
Referentie: 80416 F2
Steering lever for mounting the steering plate and steering rods.
Referentie: 80406 F3
Support for the front-end, right side of car.
Referentie: evo-023 C3
Stainless steel ball head with m4 right wire and a 4 mm hole for the serosaver to the servo
Referentie: 50445-06 B2
Bushing with conical collar for the servo saver. Inside Ø3mm Outside Ø4mm Fits ball joint (50320-20) which has a hole of Ø4mm
Referentie: 70401
Lower wishbone for the IMP4CT and FourteX. Fits front and rear, left and right
Referentie: 18924 C1
Spherical ball bearing glued in alloy anodized link.The high end spherical ball bearing has a 5mm inner diameter.The alloy link has the M8 right handed thread inside.These ball links give a significant weight reduction compared with the steel version and has a better quality bearing than the steel version.
Referentie: 80505 F4
Pinion carrier, used on the rear and front of the Fourtex.
Referentie: 18500-22
Set of sintered bronze friction plates for the dif. Comes with rings, shims and pressure springs
Referentie: 70525 B4
Collar spline for the Spline-Drive. Delivered as set
Used between the rose joints and the uprights.
Hole size: Ø5mm