- Niet op voorraad
Referentie: 45550-08 amt
Brake pads (set)
Set of brake pads for the TRAXX.
The set consists of a 2mm thick and 3mm thick brake pad.
Mount the thickest brake pad at the brake axle (inside).
- 1:10 Scale
- 1:6 Scale
- 1:8 Scale
- BBB-P Shocks
- Downloads
- ELCON
- ELCON
- Electronics
- Materials
- Silicone Oil
- Tools
Helical gear Z1 19T
Waardering
Z1 gear (pinion), mounted on the clutch bell.
19T
Omschrijving
18660-Z119T
Productdetails
18660-Z119T
Recensies
Geen klantenbeoordelingen op het moment.
16 andere producten in dezelfde categorie:
Referentie: 50320-41 A4
Shock rod-end (for M5)
Shock rod-end for shock shafts that have the M5 thread rolled ending.
Referentie: 18410-09 A2
Low Nut M8x1
Low nut (Metric fine), used for pressure adjustment of the servo saver spring
Referentie: 18660-Z120T
HELICAL GEAR Z1 20T
Z1 gear (pinion), mounted on the clutch bell.
20T
Referentie: 45900-09 C4
Rubber membrane - mark II
Rubber membrane for the air brake - mark II.
Referentie: 45506 amt
Wishbone rear L/R
Rear wishbone for the TRAXX & FourteX.
Fits both left/right side of the car.
Made from robust 7075 alloy.
Incl. bushings and adjustment bolt
Referentie: 45603 amt
Clutch bell carrier
Carrier for the clutch bell.
Delivered including bearing, shims and assembly materials.
Referentie: 18660-z316T
HELICAL GEAR Z3 16T
Pinion gear Z3 for the layshaft.
Surface of the gears can be silver or black.16T
Referentie: 45130 amt
Rings for engine
Needed as shim rings when engine is in layed down configuration.
Referentie: 51509 A1
Pin for wishbone/upright (set)
Set of 2 pins to mount the lower rear wishbone and upright together.Set comes with needed nuts and rings.
Referentie: 70201 E2
Battery strip epoxy
Battery strip from epoxy for the IMP4CT, TraxX and FourteX.
Referentie: 45608 amt
Support clutch bell
Support of the clutchbell of the TRAXX.
Includes bearing, shims and needed assembly materials.
Referentie: evo-001 A4
SEAL FOR SHOCKER - ALL SHOCKS
Seal for shocker at the piston rod.Fits all Elcon shocks.
Referentie: 70300-30green
PROGRESSIVE SPRINGS 110MM GREEN
Progressive coloured springs for the by-pass shocks, (fits also Losi and bbb-p shocks)
Length: 110mm (with thread diameter 2.1mm)
Internal diameter: 32mm
Sold als pair.
Z1 gear (pinion), mounted on the clutch bell.
19T