
Referentie: 45601 D1
Support struts for clutchbel holder (3pcs)
Support struts for the clutch bell holder to keep the clutch bell spaced and centered on the correct distance.
Clutch bell with ventilation.
Use only in combination with a teflon clutch.
18608
Geen klantenbeoordelingen op het moment.
Referentie: 45601 D1
Support struts for the clutch bell holder to keep the clutch bell spaced and centered on the correct distance.
Referentie: 45604 D4
Engine mount for the TRAXX. Allows for a standing and laying configuration of the engine. Including assembly materials.
Referentie: 50900-04 C4
Spring for the air brake.10 pcs in one bag
Referentie: samba-tc
Samba Exhaust for the Traxx, including all assembly materials. This pipe is made for a tc (horizontal) engine.Lay down engine
Referentie: 980070
Solid Elcon Models radio box. The lid has a groove in which the extra edge of the box fits, This secures a tight fit and makes the radio box watertight. Comes with a silicone wire to make the lid water tight and a rubber grommet for the servo cables. The needed hole for the grommet is to be drilled by the customer on his personal prefered position
Referentie: 45503 D4
Rear shock tower made from high grade alloy 7075. Including needed assembly materials
Referentie: 45603 D1
Carrier for the clutch bell. Delivered including bearing, shims and assembly materials.
Referentie: 70528 B4
Ring for the spline drive to secure the pin. Made from alloy, anodized and laser engraved with Elcon logo.
Referentie: 45606 D1
Gear carrier for the lay shaft of the TRAXX. Including assembly materials.
Referentie: 45620-02
6 pcs of clutch shoes for the 6-shoe teflon clutches
Referentie: 45500-02
Differential half, o-ring side. Contains only the bronze bushing pressed in the difhalf for the outgoing difcup. (Not included: difcup, bearings, oil seal etc)
Referentie: 45500-03
Differential half, gear side. Contains only the bronze bushing pressed in the difhalf for the outgoing difcup. (Not included: difcup, bearings, oil seal etc)
Referentie: 18660-z118T
Z1 gear (pinion), mounted on the clutch bell. 18 T
Clutch bell with ventilation.
Use only in combination with a teflon clutch.