
Referentie: 18807
Conical disc for steering system
Conical disc for the steering system with steel ball joints
Closure plate of the topdeck for the TRAXX.
Delivered including assembly materials.
45409
Geen klantenbeoordelingen op het moment.
Referentie: 18807
Conical disc for the steering system with steel ball joints
Referentie: 45511 B1
Splin-Drive upright for the rear of the TRAXX .and fourtex Fits both left and right side. Including bearings
Referentie: 70512-03
Insert with the amount of toe-in engraved. Can be mounted left and right. The upright slots into the insert for a rock solid mounting. Make your choice below. Available options 1,2,3,4 and 5 degrees. (Default option is 3 degrees)
Referentie: 45500-02
Differential half, o-ring side. Contains only the bronze bushing pressed in the difhalf for the outgoing difcup. (Not included: difcup, bearings, oil seal etc)
Referentie: 70512-1 D3
TRAXX 2.0 & Gunn Edition FourteX. Can be mounted left and right adjustment in wheel base possible The upright slots into the insert for a rock solid mounting Made from robust 7075 alloy. Incl:plastic bushing / screws
Referentie: 70201 E2
Battery strip from epoxy for the IMP4CT, TraxX and FourteX.
Referentie: 980070
Solid Elcon Models radio box. The lid has a groove in which the extra edge of the box fits, This secures a tight fit and makes the radio box watertight. Comes with a silicone wire to make the lid water tight and a rubber grommet for the servo cables. The needed hole for the grommet is to be drilled by the customer on his personal prefered position
Referentie: 51509 C1
Set of 2 pins to mount the lower rear wishbone and upright together.Set comes with needed nuts and rings.
Referentie: 70300-30purple
Progressive coloured springs for the by-pass shocks, (fits also Losi and bbb-p shocks) Length: 110mm (with thread diameter 2.5mm) Internal diameter: 32mm Sold als pair.
Referentie: 45620
High-end 6-shoe teflon clutch, fits TraxX, Imp4ct and FG & HPI models.The engagement point is fully adjustable over the setscrews. The clutch will tighten itself onto the crankshaft cone, by rotation of the crankshaft. The clutch can easily be removed using a M8 bolt. The clutch must be assembled by the buyer
Referentie: 45415-06 C3
Steering rod made from stainless steel. (L=105mm)
Referentie: 50750-04
For the connection of the manifold and exhaust
Closure plate of the topdeck for the TRAXX.
Delivered including assembly materials.