
Referentie: 18620-04
COVER PLATE FOR CLUTCH
Coverplate from stainless steel for the teflon clutch
Support struts for the clutch bell holder to keep the clutch bell spaced and centered on the correct distance.
45601
Geen klantenbeoordelingen op het moment.
Referentie: 18620-04
Coverplate from stainless steel for the teflon clutch
Referentie: 18410-09
Low nut (Metric fine), used for pressure adjustment of the servo saver spring
Referentie: 45120
Side guard for the TRAXX. Fits both Left and Right.
Referentie: 50445-06 B2
Bushing with conical collar for the servo saver. Inside Ø3mm Outside Ø4mm Fits ball joint (50320-20) which has a hole of Ø4mm
Referentie: 70532 B4
Center pin for the Spline-Drive. It is recommended to replace both parts Delivered as set.
Referentie: 18608
Clutch bell with ventilation.Use only in combination with a teflon clutch.
Referentie: 50121 D1
Set of pins for mounting in the side guards to fix your body on the side.Includes assembly material and body clips.
Referentie: 45602 D4
Central gear plate for the TRAXX. Delivered including assembly materials
Referentie: 70300-30white
Progressive coloured springs for the by-pass shocks, (fits also Losi and bbb-p shocks) Length: 110mm (with thread diameter 2.4mm) Internal diameter: 32mm Sold als pair.
Referentie: 45411 C2
C-hub for the TRAXX. Fits both left and right
Referentie: 980070
Solid Elcon Models radio box. The lid has a groove in which the extra edge of the box fits, This secures a tight fit and makes the radio box watertight. Comes with a silicone wire to make the lid water tight and a rubber grommet for the servo cables. The needed hole for the grommet is to be drilled by the customer on his personal prefered position
Referentie: 70521 B4
Drive shaft for the Spline-Drive. Delivered as set.
Referentie: 50900-08 C1
Wheel hex/square for the air brake.Hard anodized aluminium.Assembling materials included.
Referentie: 70300-30grey
Progressive coloured springs for the by-pass shocks, (fits also Losi and bbb-p shocks) Length: 110mm (with thread diameter 2.7mm) Internal diameter: 32mm Sold als pair.
Support struts for the clutch bell holder to keep the clutch bell spaced and centered on the correct distance.