Wishbone front
  • Wishbone front

Wishbone front

45401 C2
Waardering 

Wishbone for the front of the TRAXX.

Fits both left and right.

Made of high quality alloy

€ 60,95
Inclusief belasting
Aantal

Omschrijving

 45401

Productdetails
45401 C2
4 Items
Recensies

Geen klantenbeoordelingen op het moment.

Schrijf uw recensie

Wishbone front

Wishbone front

Wishbone for the front of the TRAXX.

Fits both left and right.

Made of high quality alloy

Schrijf uw recensie
16 andere producten in dezelfde categorie:

Referentie: 45620

Teflon clutch - 6 shoe

Beoordeling(en): 0
High-end 6-shoe teflon clutch, fits TraxX, Imp4ct and FG & HPI models.The engagement point is fully adjustable over the setscrews. The clutch will tighten itself onto the crankshaft cone, by rotation of the crankshaft. The clutch can easily be removed using a M8 bolt. The clutch must be assembled by the buyer
Meer
Op voorraad

Referentie: 70320-40 A4

Piston rod (By-Pass)

Beoordeling(en): 0
Piston rod / shock shaft with thread rolled M5 ending.By this much stronger thread rolled ending, the shock shaft is virtualy unbreakable
Meer
Op voorraad

Referentie: 50320-40-r

Piston rod (rolled M5 ending)

Beoordeling(en): 0
Piston rod / shock shaft with thread rolled M5 ending.By this much stronger thread rolled ending, the shock shaft is virtualy unbreakable.The shock rod-end that fits to this piston rod is partno: 50320-41 and 50320-42 Piston rod fits in shock absorber: 50320 and 70300
Meer
Op voorraad

Referentie: 45415 C3

Steering plate

Beoordeling(en): 0
Steering plate for the TRAXX. Allows you setting of different Ackerman angles. Delivered including full set of flanged bearings, stainless bushings and assembly materials
Meer
Op voorraad

Referentie: 980070

Radio box (EM)

Beoordeling(en): 0
Solid Elcon Models radio box. The lid has a groove in which the extra edge of the box fits, This secures a tight fit and makes the radio box watertight. Comes with a silicone wire to make the lid water tight and a rubber grommet for the servo cables. The needed hole for the grommet is to be drilled by the customer on his personal prefered position
Meer
Op voorraad

Referentie: 45500-02

Dif half (o-ring side)

Beoordeling(en): 0
Differential half, o-ring side. Contains only the bronze bushing pressed in the difhalf for the outgoing difcup. (Not included: difcup, bearings, oil seal etc)
Meer
Op voorraad

Volg ons op Facebook