
Referentie: 45900-09 C4
Rubber membrane - mark II
Rubber membrane for the air brake - mark II.
Slave axle for steeringsystem of the TRAXX.
45417
Geen klantenbeoordelingen op het moment.
Referentie: 45900-09 C4
Rubber membrane for the air brake - mark II.
Referentie: 70320-04
By-Pass shocker housing of the rear shocker
Referentie: 45900-10 C4
Brake discs for the new air brake - mark II.Sold as set
Referentie: evo-023 C3
Stainless steel ball head with m4 right wire and a 4 mm hole for the serosaver to the servo
Referentie: 70300-30orange
Progressive coloured springs for the by-pass shocks, (fits also Losi and bbb-p shocks) Length: 110mm (with thread diameter 2.2mm) Internal diameter: 32mm Sold als pair.
Referentie: 70524 B4
Spring set for the spline drive. Assures correct positioning of the drive shafts and dif shafts.
Referentie: evo-003 B4
o-rings for fixation of the alloy securement ring of the spline drive. (set)
Referentie: 70541
Complete set of spline drives shafts . 2CC of grease for the spline and 2CC of oil for lubrication of the CVD is delivered in the package. Wheel squares are not included.
Referentie: evo-0016
High grade oil for the differential.50 ml in a flacon. We advice to fill the differential with approximately 10~12ml of oil.So this is sufficient to re-fill your differential twice.
Referentie: 51105 B1
Steel down stop plates for the chassis
Referentie: 45500-03
Differential half, gear side. Contains only the bronze bushing pressed in the difhalf for the outgoing difcup. (Not included: difcup, bearings, oil seal etc)
Referentie: 50320-20 C3
Ball joint 4mm used on shocker, stabi's, servosaver
Referentie: 18660-Z119T
Z1 gear (pinion), mounted on the clutch bell. 19T
Referentie: 18807
Conical disc for the steering system with steel ball joints
Slave axle for steeringsystem of the TRAXX.