
Referentie: 50320-42 A2
Alloy Shock rod-end (for M5)
Alloy Shock rod-end with plastic bushing for shock shafts that have the M5 thread rolled ending
Z1 gear (pinion), mounted on the clutch bell.
20T
18660-Z120T
Geen klantenbeoordelingen op het moment.
Referentie: 50320-42 A2
Alloy Shock rod-end with plastic bushing for shock shafts that have the M5 thread rolled ending
Referentie: 50320-20 C3
Ball joint 4mm used on shocker, stabi's, servosaver
Referentie: 45404 C2
A-mount and shock mount for the TRAXX. Made from high grade alloy
Referentie: 70300-30red
Progressive coloured springs for the by-pass shocks, (fits also Losi shocks) Length: 110mm (with thread diameter 2.6mm) Internal diameter: 32mm Sold als pair.
Referentie: 45120
Side guard for the TRAXX. Fits both Left and Right.
Referentie: 45606 D1
Gear carrier for the lay shaft of the TRAXX. Including assembly materials.
Referentie: 70509 D3
Pin set (stainless steel) for mounting the upright / c-hub on the front- and the rear wishbone. The pin is mounted with 2 nyloc nuts and rings.
Referentie: 18410-09
Low nut (Metric fine), used for pressure adjustment of the servo saver spring
Referentie: 45511 B1
Splin-Drive upright for the rear of the TRAXX .and fourtex Fits both left and right side. Including bearings
Referentie: 70300-30orange
Progressive coloured springs for the by-pass shocks, (fits also Losi and bbb-p shocks) Length: 110mm (with thread diameter 2.2mm) Internal diameter: 32mm Sold als pair.
Referentie: 45604 D4
Engine mount for the TRAXX. Allows for a standing and laying configuration of the engine. Including assembly materials.
Referentie: 45504 D3
B-Mount for assembly of the wishbones on the rear. Including assembly materials.
Referentie: 45503-5 E2
TRAXX 2.0 & Gunn Edition FourteX. L 3 alloy insert Made from robust 7075 alloy. Incl:plastic bushing
Referentie: 45416 C3
Steering lever for the steering system of the TRAXX
Z1 gear (pinion), mounted on the clutch bell.
20T