- 1:10 Scale
- 1:6 Scale
- 1:8 Scale
- BBB-P Shocks
- Downloads
- ELCON
- ELCON
- Electronics
- Materials
- Silicone Oil
- Tools
Helical gear Z2
Waardering
Z2 gear, mounted on the layshaft.
Gear carrier 18606 is needed to mount helical gear Z2
Please select desired amount teeth.
Click on the item for further information
Omschrijving
For buggys standard is a 45 teeth gear as on picture.
All helical gears are interchangeable with each other.
Gear ratios can be altered after your personal wish, see chart in Downloads
Productdetails
18660-Z2
Recensies
Geen klantenbeoordelingen op het moment.
16 andere producten in dezelfde categorie:
Referentie: 45511 amt
Upright rear L/R
Splin-Drive upright for the rear of the TRAXX .and fourtex
Fits both left and right side.
Including bearings
Referentie: 45500-02
Dif half (o-ring side)
Differential half, o-ring side.
Contains only the bronze bushing pressed in the difhalf for the outgoing difcup.
(Not included: difcup, bearings, oil seal etc)
Referentie: 45504 amt
B-mount rear
B-Mount for assembly of the wishbones on the rear.
Including assembly materials.
Referentie: 45416 vt
Steering lever L/R
Steering lever for the steering system of the TRAXX
Referentie: 45602 amt
Central gear plate
Central gear plate for the TRAXX.
Delivered including assembly materials
Referentie: 50320-40-r
Piston rod (rolled M5 ending)
Piston rod / shock shaft with thread rolled M5 ending.By this much stronger thread rolled ending, the shock shaft is virtualy unbreakable.The shock rod-end that fits to this piston rod is partno: 50320-41 and 50320-42
Piston rod fits in shock absorber: 50320 and 70300
Referentie: evo-001 A4
SEAL FOR SHOCKER - ALL SHOCKS
Seal for shocker at the piston rod.Fits all Elcon shocks.
Referentie: 45750
EXHAUST TRAXX COMPLETE
High power exhaust for the vertical/standing engine.
Complete including manifold
Referentie: 18660-z317T
HELICAL GEAR Z3 17T
Pinion gear Z3 for the layshaft.
Surface of the gears can be silver or black. 15T
Referentie: 18660-z118T
HELICAL GEAR Z1 18T
Z1 gear (pinion), mounted on the clutch bell.
18 T
Referentie: 45620
Teflon clutch - 6 shoe
High-end 6-shoe teflon clutch, fits TraxX, Imp4ct and FG & HPI models.The engagement point is fully adjustable over the setscrews.
The clutch will tighten itself onto the crankshaft cone, by rotation of the crankshaft.
The clutch can easily be removed using a M8 bolt.
The clutch must be assembled by the buyer
Referentie: 45900-09 C4
Rubber membrane - mark II
Rubber membrane for the air brake - mark II.
Referentie: 70300-30purple
PROGRESSIVE SPRINGS 110MM PURPLE
Progressive coloured springs for the by-pass shocks, (fits also Losi and bbb-p shocks)
Length: 110mm (with thread diameter 2.5mm)
Internal diameter: 32mm
Sold als pair.
Z2 gear, mounted on the layshaft.
Gear carrier 18606 is needed to mount helical gear Z2
Please select desired amount teeth.
Click on the item for further information