- Niet op voorraad

Pinion gear Z3 for the layshaft.
Surface of the gears can be silver or black.
Please select desired amount teeth.
Click on the item for further information
Geen klantenbeoordelingen op het moment.
Referentie: 45520 B1
Adjustable shockertower extension. Makes your shocktower wider allowing a more vertical position of your rear shocks. This add lateral grip especialy on sand and cley tracks. Beside a wider position height can be adjusted as well in 3 positions for optimal use of small/big wheels.
Referentie: 45110
Body for the TRAXX. Delivered as clear shell. No decals, paint or masking tape included.
Referentie: 45550-08 D1
Set of brake pads for the TRAXX. The set consists of a 2mm thick and 3mm thick brake pad. Mount the thickest brake pad at the brake axle (inside).
Referentie: samba-s-tit
Samba Tianium Exhaust for the Traxx, including all assembly materials. This pipe is made for a standing (vertical) engine.
Referentie: 50900-04 C4
Spring for the air brake.10 pcs in one bag
Referentie: 70512-03
Insert with the amount of toe-in engraved. Can be mounted left and right. The upright slots into the insert for a rock solid mounting. Make your choice below. Available options 1,2,3,4 and 5 degrees. (Default option is 3 degrees)
Referentie: 45504 D3
B-Mount for assembly of the wishbones on the rear. Including assembly materials.
Referentie: evo-001 A4
Seal for shocker at the piston rod.Fits all Elcon shocks.
Referentie: 944300 C4
Spring lock, removeable by hand. For 4mm shaft. Sold per piece.
Referentie: 18660-Z120T
Z1 gear (pinion), mounted on the clutch bell. 20T
Referentie: 51105 B1
Steel down stop plates for the chassis
Referentie: 45561 D1
Outer part of the central brake housing. Delivered including assembly materials.
Referentie: 50900-08 C1
Wheel hex/square for the air brake.Hard anodized aluminium.Assembling materials included.
Referentie: 18620-04
Coverplate from stainless steel for the teflon clutch
Referentie: 45603 D1
Carrier for the clutch bell. Delivered including bearing, shims and assembly materials.
Referentie: 18410-09
Low nut (Metric fine), used for pressure adjustment of the servo saver spring
Pinion gear Z3 for the layshaft.
Surface of the gears can be silver or black.
Please select desired amount teeth.
Click on the item for further information