- 1:10 Scale
- 1:6 Scale
- 1:8 Scale
- BBB-P Shocks
- Downloads
- ELCON
- ELCON
- Electronics
- Materials
- Silicone Oil
- Tools
Central brake carrier
Waardering
Carrier for the central rear brake.
Including bushings, guiding pins and assembly materials.
Omschrijving
45562
Productdetails
45562 amt
Recensies
Geen klantenbeoordelingen op het moment.
16 andere producten in dezelfde categorie:
Referentie: 18701 A2
Bolt for shocker (aloy whishbones)
Bolt for mounting the shock absorber onto the aloy lower wishbones.
Referentie: 18620-03A
DISTANCE BARREL (NEW TYPE)
Distance barrel for the clutch.(since 1-1-2015)Sold per piece.Fits the 45620, 80620, 18620 and the 50620 clutch. (clutches after 1-1-2015)
Referentie: 50950-15 C4
Air seal
Air seal for pump.Always apply grease in pump housing before inserting the piston with seal.
Referentie: 70413-02 A2
Disc for pivot C-hub
Disc for the pivot of the C-hub, which is mounted on top and under the C-hub for a smooth steering of the front upright
Referentie: 45601 amt
Support struts for clutchbel holder (3pcs)
Support struts for the clutch bell holder to keep the clutch bell spaced and centered on the correct distance.
Referentie: 70413-01 A2
Distance bush / pivot C-hub
Distance bush or pivot, which is mounted in the plastic bushings for a smooth steering of the front upright
Referentie: 18660-Z120T
HELICAL GEAR Z1 20T
Z1 gear (pinion), mounted on the clutch bell.
20T
Referentie: samba-s
SAMBA PIPE FOR STANDING ENGINE
Samba exhaust for the Traxx
Including all assembly materials.
For standing engine.
Referentie: 70521 B4
Drive shaft for Spline-Drive (set)
Drive shaft for the Spline-Drive.
Delivered as set.
Referentie: 45500-02
Dif half (o-ring side)
Differential half, o-ring side.
Contains only the bronze bushing pressed in the difhalf for the outgoing difcup.
(Not included: difcup, bearings, oil seal etc)
Referentie: 70300-30grey
PROGRESSIVE SPRINGS 110MM GREY
Progressive coloured springs for the by-pass shocks, (fits also Losi and bbb-p shocks)
Length: 110mm (with thread diameter 2.7mm)
Internal diameter: 32mm
Sold als pair.
Referentie: 45604 amt
Engine mount
Engine mount for the TRAXX.
Allows for a standing and laying configuration of the engine.
Including assembly materials.
Referentie: 50900-04 C4
Spring air brake (10 pcs)
Spring for the air brake.10 pcs in one bag
Referentie: 70532 B4
CENTER PINS SPLINE-DRIVE (SET)
Center pin for the Spline-Drive.
It is recommended to replace both parts
Delivered as set.
Carrier for the central rear brake.
Including bushings, guiding pins and assembly materials.